Idle Control System

Idle Control System Diagram

When the engine is cold, the A/C compressor is on, the transmission is in gear, the brake pedal is pressed, the P/S load is high, or the alternator is charging, the PCM controls current to the AC valve to maintain the correct idle speed. Refer to the System Diagram to see the functional layout of the system.




The idle speed of the engine is controlled by the idle air control (IAC) valve:
- After the engine starts, the IAC valve opens for a certain amount of time. The amount of air is increased to raise the idle speed.
- When the engine coolant temperature is low, the IAC valve is opened to obtain the proper fast idle speed. The amount of bypassed air is thus controlled in relation to engine coolant temperature.

Brake Pedal Position Switch

The brake pedal position switch signals the PCM when the brake pedal is pressed.

Idle Air Control (IAC) Valve




To maintain the proper idle speed, the IAC valve changes the amount of air bypassing the throttle body in response to an electrical signal from the PCM.

Power Steering Pressure (PSP) Switch

The PSP switch signals the PCM when the power steering load is high.

Starter (Ignition) Switch

The starter switch signals the PCM when the engine is cranking.