How to End A Troubleshooting Session

How to End a Troubleshooting Session
This procedure must be done after any troubleshooting.
1. Turn the ignition switch OFF.
2. Reset the PCM.
3. Disconnect the OBD II Scan Tool or the Honda PGM Tester from the Data Link Connector (16P) (D).
4. Turn the ignition switch ON (II).
5. Enter the radio code, reset the preset stations, and set the clock.
6. Perform the PCM idle learn procedure.
7. To verify that the problem is repaired, test-drive the vehicle for several minutes at speeds over 30 mph (48 km/h).