Indicator Input Test

Indicator Input Test
SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section before performing repairs or service.
1. Remove the gauge assembly from the dashboard, then disconnect the A (30P) and C (14P) connectors from the gauge assembly.
2. Inspect the connectors and connector terminals to be sure they are making good contact.
3. If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.











4. Perform the following input test et the gauge assembly A (30P) and C (14P) connectors.
5. Connect the A (30P) and C (14P) connectors to the gauge assembly, then perform the following input test.





6. If all the input tests prove OK, but the indicator is faulty, replace the printed circuit board.