Intermediate Shaft Reassembly

Intermediate Shaft Reassembly

Special Tools Required
- Driver 07749-0010000
- Support base attachment 07LAF-SM40300
- Support base 07965-SD90100
- Oil seal driver attachment 07947-SD90101
- Fork seal driver, 39.2 x 49.5 x 15 mm 07947-4630100

NOTE: Refer to the Exploded View as needed during this procedure.

1. Clean the disassembled parts with solvent, and dry them with compressed air. Do not wash the rubber parts with solvent.





2. Press the intermediate shaft bearing (A) into the bearing support (B) using the special tools and a press.





3. Seat the internal snap ring into the groove of the bearing support.





4. Press the intermediate shaft (A) into the shaft bearing using the special tool and a press.





5. Seat the external snap ring (A) into the groove of the intermediate shaft (B).





6. Pack the interior of the outer seal (A). Install the outer seal into the bearing support (B) using the special tools and a press.
7. Install the heat shield onto the bearing support.