DTC 11

ABS DTC 11: Wheel Sensor (Open/ Short to Body Ground/Short to Power)
1. Disconnect ABS/TCS control unit connector A (26P).
2. Start the engine.








3. Measure the voltage between the appropriate wheel sensor (+) circuit terminal and body ground (see table).
Is there 1 V or more?
YES-Repair short to power in the (+) circuit wire between the ABS/TCS control unit and the appropriate wheel sensor.
NO-Go to step 4.








4. Check for continuity between the appropriate wheel sensor (+) circuit terminal and body ground (see table).
Is there continuity?
YES-Go to step 5.
NO-Go to step 6.
5. Disconnect the harness 2P connector from the appropriate wheel sensor, then check for continuity between the No. 1 and No. 2 terminals of the harness and body ground.
Is there continuity?
YES-Repair short to body ground in the No. 1 or No. 2 circuit wire between the ABS/TCS control unit and the wheel sensor.
NO-Replace the wheel sensor.








6. Check the resistance between the appropriate wheel sensor (+) and (-) circuit terminals (see table).
Is the resistance between 450 - 2,000 ohms ?
YES-Check for loose ABS/TCS control unit connectors. If necessary, substitute a known-good ABS/TCS control unit, and recheck.
NO-Go to step 7.
7. Disconnect the harness 2P connector from the appropriate wheel sensor, and check the resistance between the (+) and (-) terminals of the wheel sensor.
Is the resistance between 450 - 2,000 ohms ?
YES-Repair open in the (+) or (-) circuit wire, or short between the (+) circuit wire and the (-) circuit wire between the ABS/TCS control unit and the wheel sensor.
NO-Replace the wheel sensor.