M/T Model

DTC P1106: Range/Performance Problem in BARO Sensor Circuit - M/T Model

1. Reset the ECM.
2. Start the engine. Hold the engine at 3,000 rpm with no load (in Park or neutral) until the radiator fan comes on, then let it idle.
3. Test-drive with the shift lever in 2nd gear.
4. Accelerate for five seconds using wide open throttle.
5. Check for a Temporary DTC with the scan tool.

Is Temporary DTC P1106 indicated?

YES - Substitute a known-good ECM and recheck. If the symptom/indication goes away, replace the original ECM.

NO - Intermittent failure, system is OK at this time.