Undercoating
Undercoating1. Masking
Mask the area surrounding the damage to prevent over spray from the primer surfacer.
Use masking tape and paper.
2. Spraying the primer surfacer
- Spray the primer surfacer over a wider area than the body filler and the exposed surface of the paint film.
- Spray 2-3 coats to get 30 microns of thickness.
- Use a 2-part urethane primer surfacer and a spray gun.
- Mix the primer surfacer with the additive and solvent, and in the correct ratio.
- Follow the primer surfacer manufacturer's instructions.
3. Drying
After spraying the primer surfacer, allow for 5 to 10 minutes of normal drying time, then force dry it with infrared lamps or an industrial dryer.
NOTE: Follow the primer surfacer manufacturer's instructions for drying time.
4. Polishing
Check that the primer surfacer has dried thoroughly, then sand the primer surfacer.
Use a double action sander and #320-#400-#600 disc sandpaper.
5. Air blowing / degreasing
Use alcohol, and wax and grease remover.
Also, clean and degrease the surfaces where masking tape will be attached.