Operation CHARM: Car repair manuals for everyone.
Home >> Acura >> 2002 >> CL V6-3.2L SOHC >> Repair and Diagnosis >> Restraints and Safety Systems >> Relays and Modules - Restraints and Safety Systems >> Air Bag Control Module >> Service and Repair >> SRS Unit Replacement

SRS Unit Replacement

Removal

1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Disconnect the driver's and front passenger's airbag connectors.
3. Disconnect the side airbag connectors.
4. Disconnect both seat belt tensioner connectors.
5. Remove the console panel.




6. Disconnect the connectors (A) from the SRS unit.




7. Remove the three Torx bolts (A) from the SRS unit, then pull out the SRS unit from the bracket.

Installation




1. Install the new SRS unit (A) with Torx bolts (B), then connect the connectors (C) to the SRS unit, and push them into place until they click.

NOTE: When tightening the Torx bolts to the specified torque after replacement, be careful to turn them in so that their heads rest squarely on the brackets.

2. Install the console panel.
3. Reconnect the driver's and front passenger's airbag connectors.
4. Reconnect the side airbag connectors.
5. Reconnect both seat belt tensioner connectors.
6. Reconnect the battery negative cable.
7. Initialize the OPDS unit.
8. After installing the SRS unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator light should come on for about 6 seconds and then go off.
pro multis · About Operation CHARM