Automatic Transmission/Transaxle: Adjustments

NOTE: Select the appropriate manual valve detent spring when these parts are replaced:
- Manual Valve
- Manual Valve Detent Spring
- Manual Valve Lever of Control Shaft

1. Install the main valve body, including the ATF pump gears, onto the torque converter housing, and tighten the main valve body bolts to 12 Nm (8.7 ft. lbs.).
2. Install the control shaft.
3. Install the manual valve detent spring on the main valve body and tighten the spring bolt to 14 Nm (10 ft. lbs.).
4. Set the manual valve to the N position.





5. Measure the distance between the main valve body and manual valve as shown.
- Distance: 28.0 - 29.0 mm (1.102 - 1.142 inch).





6. If the measurement is out of tolerance, select the appropriate manual valve detent spring using the table, then install it and recheck it.