Front

NOTE: Use only genuine Acura wheel weights for aluminum wheels. Non-genuine wheel weights may corrode and damage the aluminum wheels. On the aluminum wheels, remove the center cap from inside of the wheel after removing the wheel. Before installing the brake disc, clean the mating surface of the front hub and inside of the brake disc. Before installing the wheel, clean the mating surfaces of the brake disc and inside of the wheel.





1. Loosen the wheel nuts slightly.
2. Raise the front of vehicle, and support it on safety stands in proper locations.





3. Remove the wheel nuts and wheel.

NOTE: Before installing the wheel, clean the mating surfaces of the brake disc and inside of the wheel.





4. Remove the brake hose mounting bolts.





5. Remove the wheel sensor from the knuckle and front lower control arm.

CAUTION: Do not disconnect the wheel sensor. Be careful when installing the sensors to avoid twisting wires.





6. Remove the caliper bracket mounting bolts, and hang the caliper assembly to one side.

CAUTION: To prevent accidental damage to the caliper assembly or brake hose, use a short piece of wire to hang the caliper assembly from the undercarriage.





7. Remove the flat head screws. Install two 8 x 12 mm bolts into the disc to push it away from the hub.

CAUTION: Turn each bolt two turns at a time to prevent cocking the disc excessively.





8. Remove the hub unit from the knuckle.