Restraint System - 'SIDE AIRBAG OFF' Indicator ON
02-021September 9, 2002
Applies To:
2002 RSX - ALL
SIDE AIRBAG OFF Indicator Comes On
SYMPTOM
The SIDE AIRBAG OFF indicator comes on when there are no objects on the front passenger's seat cushion; the seat-back is dry; and there are no aftermarket seat covers, cushions, or backrest installed.
Typical customer complaints are
^ The indicator comes on and stays on after turning the ignition switch to ON (II). (The indicator should come on briefly, and then go off.)
^ The indicator comes on and stays on while driving.
^ The indicator blinks intermittently while driving.
^ The indicator blinks intermittently with the vehicle stationary.
PROBABLE CAUSE
A faulty OPDS unit.
CORRECTIVE ACTION
If the SIDE AIRBAG OFF indicator comes on and stays on or blinks intermittently when there are no objects on the front passenger's seat cushion; the seat-back is thoroughly dry; and there are no aftermarket seat covers, cushions, or backrest installed, replace the OPDS unit.
PARTS INFORMATION
OPDS Unit: P/N 81334-S6M-A02
WARRANTY CLAIM INFORMATION
In warranty: The normal warranty applies.
Operation Number: 751109
Flat Rate Time: 0.3 hour
Failed Part: P/N 81334-S6M-A01
Defect Code: 032
Contention Code: B03
Template ID: 02-021A
Skill Level: Repair Technician
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone Office. You must request consideration, and get a decision, before starting work.
DIAGNOSIS
1. Make sure there are no objects on the front passenger's seat cushion; the seat-back is thoroughly dry; and there are no aftermarket seat covers, cushions, or backrest installed. Turn the ignition switch to ON (II).
Does the SIDE AIRBAG OFF indicator come on and stay on or blink intermittently?
Yes - Go to REPAIR PROCEDURE.
No - Go to step 2.
2. Ask your customer about the condition of the seat when the indicator came on.
Was there anything on the seat cushion; was the seat-back wet; or was an aftermarket seat cover; cushion, or backrest installed?
Yes - Return the vehicle to your customer. Advise him or her (1) to make sure the front seat passenger is sitting up properly in the seat, (2) to keep objects (grocery bags, brief cases, laptop computers) off the front passenger's seat cushion, (3) to avoid getting the front passenger's seat-back wet, and (4) to never use aftermarket seat covers, cushions, or backrest on the front seats.
No - Go to REPAIR PROCEDURE.
REPAIR PROCEDURE
1. Make sure you have the anti-theft code for the radio, then write down your customer's radio station presets.
2. Turn the ignition switch to LOCK (0).
3. Disconnect the negative battery cable, then wait at least 3 minutes before you start work.
4. Unzip the two seat cover zippers on the back of the front passenger's seat.
5. Pull back the seat-back cover from the left side bolster to give you access to the OPDS unit cover.
6. Remove the OPDS unit cover from the seat frame (three clips).
7. Recline the seat-back to give you access to the two OPDS unit mounting screws.
8. Remove the mounting screws from the OPDS unit, and gently pull out the unit.
9. Unplug the OPDS unit 8P and sensor connectors, then remove the unit.
10. Install the new OPDS unit. Reinstall the OPDS unit cover.
11. Slip the seat-back cover over the left side bolster.
12. Zip the seat-back cover closed.
13. Reconnect the negative battery cable.
14. Initialize the OPDS (see S/B 02-020, Initializing the Occupant Position Detection System, found under Restraints).
15. Do the idle learn procedure:
^ Make sure all electrical items (A/C, audio unit, defogger, lights, etc.) are turned off, then start the engine.
^ Let the engine reach its normal operating temperature (the cooling fan cycles twice).
^ Let the engine idle (throttle fully closed and with all electrical items off) for 10 minutes.
16. Initialize the driver's window auto-up.
17. Enter the anti-theft code for the radio. Enter your customer's radio station presets.
15. Set the clock.
Disclaimer