Main Valve Body Disassembly, Inspection and Reassembly

Disassembly, Inspection, and Reassembly
1. Clean all parts thoroughly in solvent or carburetor cleaner, and dry them with compressed air. Blow out all passages.
2. Do not use a magnet to remove the check ball, it may magnetize the ball.
3. Check all valves for free movement. If any fail to slide freely, refer to Valve Body Repair. Valve Body Repair
4. Replace the valve body as an assembly if any parts are worn or damaged.
5. Coat all parts with ATF during assembly.





6. Install the filter in the direction shown.





Sectional View