System Description

Power Windows

System Descriptions

'03 model







The driver's window will stop and automatically open if you pinch your hand or something during auto-up operation.
The system is composed of the power window master switch, the power window control unit and the driver's window motor.
The power window motor incorporates a pulser which generates pulses during the motor's operation and sends the pulses to the power window control unit. As soon as the power window control unit detects that no pulses are oscillated from the pulser, the control unit makes the power window motor stop and reverse.

Power Window Control Unit Reset
Resetting the power window control unit is required after performing the following procedures:
- disconnecting of the battery.
- loss of electric power caused by both No. 8 (20 A) and No. 15 (20 A) fuses in the passenger's under-dash fuse/relay box.
- open circuit caused by disconnected 18P connector form the power window control unit.
- removal of the regulator, glass or glass run channel.
- open circuit caused by disconnecting the subharness attached to the door liner.

1. Make sure the glass is installed properly.
2. Make sure the driver's window does not work in AUTO with the ignition switch ON (II).
3. Lower the driver's window all the way down by manual down using the driver's switch of the master switch, and then hold for more than one second.
4. Raise the driver's window all the way up by manual up using the driver's switch of the master switch, and then hold for more than one second.