Front Seat

Front Seat Removal/Installation

'00-03 models: SRS components are located in this area. Review the SRS component locations and the precautions and procedures in the SRS section before performing repairs or service.

1. '00-03 models: Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio preset buttons. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.




2. Remove the seat track end covers (A), and remove the bolts securing the front seat (B). When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage. Take care not to scratch the body or tear the seat covers.



















3. Lift up the front seat, then disconnect the seat harness connector (A). On '00-01 models, disconnect the side airbag connector (B). And on the '00-01 models passenger's seat only, disconnect the OPDS unit connector (C), and detach the harness clips (D) and connector clip (E).
4. With the help of an assistant, carefully remove the front seat through the front door opening.
5. Install the seat in the reverse order of removal, and note these items:
- Make sure the seat harness connector is connected properly.
- '00-03 models: Enter the anti-theft code for the radio, then enter the customer's radio station presets.
- '00-03 models: Reset the clock.