Mainshaft, A/T

Mainshaft	Diameter of needle bearing contact area	at stator shaft	Standard or new	22.984 - 23.000 mm
			Service limit	When worn or damaged
		at 5th gear	Standard or new	51.975 - 51.991 mm
			Service limit	When worn or damaged
		at 4th gear collar	Standard or new	33.975 - 33.991 mm
			Service limit	When worn or damaged
	I.D. of gears	5th gear	Standard or new	57.000 - 57.019 mm
			Service limit	When worn or damaged
		4th gear	Standard or new	40.000 - 40.016 mm
			Service limit	When worn or damaged
	End play of gears	5th gear	Standard or new	0.03 - 0.11 mm
		4th gear	Standard or new	0.1 - 0.212 mm
	41 x 68 mm thrust washer thickness	No.1	Standard or new	6.35 mm
			Service limit	When worn or damaged
		No.2	Standard or new	6.40 mm
			Service limit	When worn or damaged
		No.3	Standard or new	6.45 mm
			Service limit	When worn or damaged
		No.4	Standard or new	6.50 mm
			Service limit	When worn or damaged
		No.5	Standard or new	6.55 mm
			Service limit	When worn or damaged
		No.6	Standard or new	6.60 mm
			Service limit	When worn or damaged
	4th gear collar length		Standard or new	66.3 - 66.4 mm
	Length of 4th gear collar flange from end		Standard or new	19.15 - 19.30 mm
			Service limit	When worn or damaged
	Sealing ring thickness		Standard or new	1.91 - 1.97 mm
			Service limit	1.86 mm
	Width of sealing ring groove		Standard or new	2.025 - 2.060 mm
			Service limit	2.080 mm
	Clutch feed pipe O.D.		Standard or new	7.97 - 7.98 mm
			Service limit	7.95 mm
	Clutch feed pipe bushing I.D.		Standard or new	8.000 - 8.015 mm
			Service limit	8.030 mm