Power Window Control Module: Testing and Inspection

Resetting the Power Window Control Unit

Resetting the power window control unit is required after performing the following procedures:
- Shutdown of the battery power
- Shutdown of the electric power caused by the No.6 (7.5 A) and/or the No.23 (20 A) fuses in the under-dash fuse/relay box.
- Open circuit caused by disconnected 1P connector from the power window master switch
- Removal of the regulator, glass, or glass run channel

1. Make sure the glass is installed properly.
2. Close the driver's door.
3. Turn the ignition switch OFF.
4. Remove the No.23 (20 A) fuse in the under-dash fuse/relay box.
5. Turn the ignition switch ON (II).
6. After 1 second, turn the ignition switch OFF.
7. After 5 seconds, install the No.23 (20 A) fuse to the under-dash fuse/relay box.
8. Make sure the driver's window does not work in AUTO with the ignition switch ON (II).
9. Turn the ignition switch to START (III), and start the engine.
10. Move the driver's window all the way down using the manual DOWN function of the driver's power window switch.
11. Move the driver's window all the way up using the manual UP function of the driver's power window switch and holding it for 1 second after the window reaches the closed position.
12. If the window does not work in AUTO, repeat steps 2 through 12.