Carpet: Service and Repair

Replacement

SRS components are located in this area. Review the SRS component locations, precautions, and procedures before performing repairs or service.

1. Remove:
- Seats
- Footrest
- Under-dash fuse box lid
- Side sill trim
- Side sill pad
- Rear side trim panel
- Center armrest
- Center console panel

2. Detach the clips at the front edge (passenger's).
3. Remove the console carpet attaching screw from the heater unit (passenger's).




4. Disconnect the air duct (driver's) and air vent, then remove the carpet hooks from the dashboard inside screws.
5. Pull up the retainers, then remove the floor carpets.




6. Remove the console carpets.
7. Installation is the reverse of the removal procedure.

NOTE:
- Take care not to damage, wrinkle or twist the carpets.
- Make sure the air vents are connected into the heater unit and air duct.
- Make sure the seat harnesses are routed correctly.