P0775

DTC P0775: Problem in the Hydraulic Control System of A/T Clutch Pressure Control Solenoid Valve B Circuit

NOTE: Record all freeze data before you troubleshoot.

1. Check whether the OBD II scan tool indicates another code.
Does the OBD II scan tool indicate another code?
YES - Perform the troubleshooting flowchart for the indicated code(s). Turn the ignition switch OFF, and go to step 4 after troubleshooting.
NO - Go to step 2.
2. Turn the ignition switch OFF.
3. Replace the A/T clutch pressure control solenoid valve B (with C as a set).
4. Reset the PCM memory by removing the No. 6 ECU (15 A) fuse in the under-hood fuse/relay box for more than 10 seconds.
5. Start the engine, and shift to the M position. Test drive the vehicle in 2nd gear at 25 mph (40 km/h) for 10 seconds, shift to 3rd gear, drive at 25 mph (40 km/h) for 10 seconds, then decelerate to a stop. Do not stop the engine. Start off in 1st gear in the M position, and drive in 1st gear at 19 mph (30 km/h) for 10 seconds.
6. Repeat step 5 to test-drive the vehicle.
7. Recheck for DTC P0775.
Does the OBD II scan tool indicate code P0775?
YES - Replace the transmission assembly.
NO - The problem has been corrected.