P0795
DTC P0795: Problem in Hydraulic Control System of A/T Clutch Pressure Control Solenoid Valve C CircuitNOTE: Record all freeze data before you troubleshoot.
1. Check whether the OBD II scan tool indicates another code.
Does the OBD II scan tool indicate another code?
YES - Perform the troubleshooting flowchart for the indicated code(s). Turn the ignition switch OFF, and go to step 4 after troubleshooting.
NO - Go to step 2.
2. Turn the ignition switch OFF.
3. Replace the A/T clutch pressure control solenoid valve C (with B as a set).
4. Reset the PCM memory by removing the No. 6 ECU (15A) fuse in the under-hood fuse/relay box for more than 10 seconds.
5. Drive the vehicle in M position, and drive in 5th gear at 25 mph (40 km/h) for 10 seconds, then downshift to 3rd gear. Drive in 3rd gear at 25 mph (40 km/h) for 10 seconds, and decelerate to a stop.
6. Recheck for DTC P0795.
Does the scan tool indicate code P0795?
YES - Go to step 7.
NO - The problem has been corrected.
7. Check for warranty coverage.
Is the vehicle under warranty?
YES - Replace the transmission assembly.
NO - Go to step 8.
8. Turn the ignition switch OFF.
9. Remove the transmission, and overhaul transmission hydraulic control system and the 3rd and 5th clutch lines.
10. Install the transmission on the vehicle.
11. Reset the PCM memory by removing the No. 6 ECU (15A) fuse in the under-hood fuse/relay box for more than 10 seconds.
12. Drive the vehicle in M position, and drive in 5th gear at 25 mph (40 km/h) for 10 seconds, then downshift to 3rd gear. Drive in 3rd gear at 25 mph (40 km/h) for 10 seconds, and decelerate to a stop.
13. Recheck for DTC P0795.
Does the scan tool indicate code P0795?
YES - Replace the transmission assembly.
NO - The problem has been corrected.