P1106

DTC P1106: BARO Sensor Range/Performance Problem

NOTE: Information marked with an asterisk (*) applies to '04 model.

1. Reset the ECM/PCM.
2. Start the engine. Hold the engine at 3,000 rpm with no load (in Park or neutral) until the radiator fan comes on, then let it idle.
3. Test-drive with the A/T in 2, or the M/T in 4th gear.
4. Accelerate for 5 seconds using wide open throttle.
5. Check for a Temporary DTC with the scan tool or the HDS.

Is Temporary DTC P1106 (P2227)* indicated?

YES - Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM.then recheck. If the symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/PCM.

NO - Intermittent failure, system is OK at this time.