Front

Replacement
1. Raise the front of the vehicle, and make sure it is securely supported. Remove the front wheels.





2. Remove the self-locking nuts (A) while holding the joint pin (B) with a hex wrench (C), and disconnect the stabilizer links (D) from the stabilizer bar (E) on the right and left.





3. Remove the flange bolts (A) and bushing holders (B), then remove the bushings (C) and the stabilizer bar (D).





4. Install the stabilizer bar in the reverse order of removal, and note these items:
^ Use new self-locking nuts on reassembly.
^ Note the right and left direction of the stabilizer bar.
^ Align the ends of the paint marks (A) on the stabilizer bar with each end of the bushings (B).
^ Note the fore/aft direction of the bushing holders.
^ Refer to Stabilizer Link Replacement to connect the stabilizer bar to the links.