B1063

B1063: Relay Control Module lost communication with Combination Switch Control Unit (wiper switch message)

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN system diagnosis test mode A.

1. Clear the DTCs with the HDS.
2. Turn the ignition switch OFF and then back ON (II).
3. Check for DTCs with the HDS.

Is DTC B1055, B1056, B1057, B1058, B1059, B1060, B1061, B1062 and/or B1063 indicated?

YES - Go to step 4.

NO - Intermittent failure, the communication line is OK at this time.

4. Check for DTCs other than those listed at previous step.

Are any other DTCs present?

YES - Go to step 5.

NO - Perform Relay Control Module Input Test.




5. Find the chart that contains at least one retrieved DTC in column A and one retrieved DTC in column B. Perform the input test for the ECU listed in that chart.
If no DTC from column B is found, then continue to Relay Control Module Input Test.