Operation CHARM: Car repair manuals for everyone.

DTC 22

DTC 22: Magnetic Encoder (front)
1. Clear the DTC using the HDS.
2. Disconnect the HDS from the 16P DLC.
3. Cycle the ignition switch (turn ON (II), then OFF).
4. Test-drive the vehicle at 19 mph (30 km/h) or more.
Does the ABS indicator come on, and are DTCs 21, 22, 23, and/or 24 indicated?
YES - Go to step 5.
NO - The system is OK at this time.





5. Check the appropriate magnetic encoder or pulser for debris or damage (see table).
Is the encoder or pulser OK?
YES - Check for loose terminals in the VSA control unit 47P connector. If necessary, substitute a known-good VSA modulator-control unit, and recheck.
NO - Clean and reinstall or replace the magnetic encoder or pulser.
6. Clear the DTCs using the HDS.
7. Disconnect the HDS from the 16P DLC.
8. Cycle the ignition switch OFF, ON (II), and OFF.
9. Test-drive the vehicle at speeds above 19 mph (30 km/h).
Does the ABS indicator come on?
YES - Check for a loose VSA control unit 47P connector. If necessary, substitute a known-good VSA modulator-control unit, and rechecked
NO - Replace the original wheel sensor, encoder, or pulser.