P0122
DTC P0122: TP Sensor A Circuit Low Voltage1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Check TP SENSOR-A in the DATA LIST with the HDS.
Is there about 0.3 V or less when the throttle is fully opened?
YES - Go to step 4.
NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the throttle body and the throttle actuator control module.
4. Check for Temporary DTCs or DTCs with the HDS.
Are DTC P0122 and P0222 indicated at the same time?
YES - Check for poor connections or loose terminals at the throttle body, the throttle actuator control module, and at the ECM/PCM, then go to step 17. If the connections are OK, go to step 9.
NO - Go to step 5.
5. Turn the ignition switch OFF.
6. Disconnect the throttle body 6P connector.
7. Disconnect the throttle actuator control module 16P connector.
8. Check for continuity between throttle body 6P connector terminal No.1 and body ground.
Is there continuity?
YES - Repair short in the wire between the throttle body and the throttle actuator control module (TPSA line), then go to step 17.
NO - Substitute a known-good throttle actuator control module, then go to step 17 and recheck. If DTC P0122 is not indicated, replace the original throttle actuator control module, then go to step 17. If DTC P0122 is indicated, go to step 15.
9. Measure voltage between throttle body 6P connector terminal No.2 and body ground.
Is there about 5 V?
YES - Go to step 15.
NO - Go to step 10.
10. Turn the ignition switch OFF.
11. Disconnect the throttle actuator control module 16P connector.
12. Disconnect the throttle body 6P connector.
13. Connect throttle body 6P connector terminal No.2 to body ground with a jumper wire.
14. Check for continuity between throttle actuator control module 16P connector terminal No.11 and body ground.
Is there continuity?
YES - Substitute a known-good throttle actuator control module, then go to Step 17 and recheck. If DTC P0122 is not indicated, replace the original throttle actuator control module, then go to step 17. If DTC PO122 is indicated, go to step 15.
NO - Repair open in the wire between the throttle body and the throttle actuator control module (VCC line), then go to step 17.
15. Turn the ignition switch OFF.
16. Replace the throttle body.
17. Turn the ignition switch ON (II).
18. Reset the ECM/PCM with the HDS.
19. Do the ECM/PCM idle learn procedure.
20. Check for Temporary DTCs or DTCs with the HDS.
Are any Temporary DTCs or DTCs indicated?
YES - If DTC P0122 is indicated, check for poor connections or loose terminals at the throttle body and the throttle actuator control module, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.
NO - Troubleshooting is complete.