P0506

DTC P0506: Idle Control System RPM Lower Than Expected

1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine. Hold the engine speed at 3,000 rpm with no load (in Park or neutral) until the radiator fan comes on, then let it idle.
4. Check this data in the DATA LIST with the HDS:

- Engine coolant temperature more than 156 °F (70 °C)
- Intake air temperature more than 32 °F (0 °C)
- Vehicle speed is 0 mph (0 km/h)
- AF FB between 0.73 and 1.47
- FSS is CLOSED

5. Monitor the OBD STATUS for DTC P0506 in the DTCs MENU with the HDS.

Does the screen indicated FAILED?

YES - Go to step 6.

NO - If the screen indicates PASSED, go to step 15. If the screen indicates EXECUTING, let the engine idle until a result comes on. If the screen indicates OUT OF CONDITION, go to step 4 and recheck.

6. Remove the intake air duct from the throttle body.
7. Check for dirt, carbon, or damage in the throttle bore.

Is there dirt, carbon, or damage in the throttle bore?

YES - If there is dirt or carbon, clean the throttle body, and also check for damage at the air cleaner element, then go to step 9. If there is damage in the throttle bore, go to step 8.

NO - Check the A/C system or power steering system, then go to step 17.

8. Replace the throttle body.
9. Reset the ECM/PCM with the HDS.
10. Do the ECM/PCM idle learn procedure.
11. Start the engine, Hold the engine speed at 3,000 rpm with no load (in Park or neutral) until the radiator fan comes on, then let it idle.
12. Check this data in the DATA LIST with the HDS:

- Engine coolant temperature more than 156 °F (70 °C)
- Intake air temperature more than 32 °F (0 °C)
- Vehicle speed is 0 mph (0 km/h)
- AF FB between 0.73 and 1.47
- FSS is CLOSED

13. Check for Temporary DTCs or DTCs with the HDS.

Are any Temporary DTCs or DTCs indicated?

YES - If DTC P0506 is indicated, go to step 1 and recheck. If any other temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.

NO - Go to step 14.

14. Monitor the OBD STATUS for DTC P0506 in the DTCs MENU with the HDS.

Does the screen indicate PASSED?

YES - Troubleshooting is complete.

NO - If the screen indicates FAILED, go to step 1 and recheck. If the screen indicates EXECUTING, let the engine idle until a result comes on. If the screen indicates OUT OF CONDITION, go to step 12 and recheck.

15. Remove the intake air duct from the throttle body.
16. Check for dirt, carbon, or damage in the throttle bore.

Is there dirt, carbon, or damage in the throttle bore?

YES - If there is dirt or carbon, clean the throttle body, and also check for damage at the air cleaner element, then go to step 9. If there is damage in the throttle bore, go to step 8.

NO - Go to step 17.

17. Recheck with different load conditions (turn on the headlights, blower motor, rear window defogger and/or NC, changing the gear position, etc.).
18. Monitor the OBD STATUS for DTC P0506 in the DTCs MENU with the HDS.

Does the screen indicate PASSED?

YES - Intermittent failure, system is OK at this time.

NO - If the screen indicates FAILED, check the A/C system and/or power steering system, then go to step 1 and recheck. If the screen indicates EXECUTING, let the engine idle until a result comes on. If the screen indicates OUT OF CONDITION, go to step 17 and recheck.