P0762

DTC P0762: Shift Solenoid Valve C Stuck ON

NOTE: Record all freeze data and review General Troubleshooting Information before you troubleshoot.

1. Warm up the engine to normal operating temperature (the radiator fan comes on).
2. Check to be sure that the transmission is filled to the proper level, and check for fluid leaks.
3. Drain the ATF through a paint strainer. Look for contamination (small peaces of metal or friction material) in the strainer.

NOTE: If little or no contamination is found in the strainer, the ATF is OK. Discoloration, small chips or flakes, metal fuzz and a slightly "burnt" smell is considered normal.

Is the ATF OK?
YES-Replace the ATF, then go to step 4.
NO- Repair or replace the transmission.
4. Clear the DTC with the HDS.
5. Test-drive the vehicle in the D position in all five gears at speeds over 12 mph (20 km/h) for more than 20 second, then slow down to a stop.
6. Retest-drive the vehicle in the D position in all five gears at speeds over 12 mph (20 km/h) for more than 20 second, then slow down to a stop.
7. Check the OBD STATUS in DTCs MENU for a pass/fail test of code P0762.
Did the result indicate a fail?
YES-Go to step 8.
NO-Intermittent failure, the system is OK at this time. If the tester indicates NOT COMPLETE, return to step 5 and recheck.
8. Clear the DTC with the HDS.
9. Select SHIFT SOL TEST in MISCELLANEOUS TEST MENU, then carry out A/T SHIFT SOL C test in SHIFT SOL TEST MENU with the HDS.
Is a clicking sound heard?
YES-Go to step 10.
NO-Replace shift solenoid valve C, then go to step 13.
10. Test-drive the vehicle in the D position in all five gears at speeds over 12 mph (20 km/h) for more than 20 second, then slow down to a stop.
11. Retest-drive the vehicle in the D position in all five gears at speeds over 12 mph (20 km/h) for more than 20 second, then slow down to a stop.
12. Check the OBD STATUS in DTCs MENU for a pass/fail test of code P0762.
Did the result indicate a fail?
YES-Repair shift valves C and E, or replace the transmission, then go to step 13.
NO-Intermittent failure, the system is OK at this time. If the tester indicates NOT COMPLETE, return to step 10 and rechecks
13. Clear the DTC with the HDS.
14. Test-drive the vehicle in the D position in all five gears at speeds over 12 mph (20 km/h) for more than 20 second, then slow down to a stop.
15. Retest-drive the vehicle in the D position in all five gears at speeds over 12 mph (20 km/h) for more than 20 second, then slow down to a stop.
16. Check the OBD STATUS in DTCs MENU for a pass/fail test of code P0762.
Did the result indicate a pass?
YES-The problem has been corrected.
NO-Return to step 1 and recheck.