P0872
DTC P0872: Short in 4th Clutch Transmission Fluid Pressure Switch Circuit, or 4th Clutch Transmission Fluid Pressure Switch Stuck ONNOTE:
^ Record all freeze data and review General Troubleshooting Information before you troubleshoot.
^ This code (if not accompanied by other DTCs) is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
1. Clear the DTC with the HDS.
2. Check the 4th PRESSURE SWITCH signal with the HDS in the A/T data list when not in 4th gear.
Is the 4th PRESSURE SWITCH ON?
YES-Go to step 5.
NO-Go to step 3.
3. Start the engine, and warm it up to normal operating temperature (the radiator fan comes on). Drive the vehicle in 4th gear in the M position for more than 5 seconds. Slow down and stop the wheels.
4. Check the OBD STATUS in DTCs MENU for a pass/fail test for code P0872.
Did the result indicate a fail?
YES-Go to step 5.
NO-Intermittent failure, the system is OK at this time. Check the BLU/YEL wire for an intermittent short to ground between the 4th clutch transmission fluid pressure switch and PCM. If the tester indicates NOT COMPLETE, return to step 3 and rechecks
5. Turn the ignition switch OFF.
6. Disconnect the 4th clutch transmission fluid pressure switch connector.
7. Turn the ignition switch ON (II).
8. Check the 4th PRESSURE SWITCH signal with the HDS in the A/T data list.
Is the 4th PRESSURE SWITCH ON?
YES-Replace the 4th clutch transmission fluid pressure switch. then go to step 13.
NO-Go to step 9.
9. Turn the ignition switch OFF.
10. Jump the SCS line with the HDS.
11. Disconnect PCM connector C (22P).
12. Check for continuity between PCM connector terminal C13 and body ground.
Is there continuity?
YES-Repair short to ground in the wire between PCM connector terminal C13 and the 4th clutch transmission fluid pressure switch, then go to step 13.
NO-Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If the symptom/indication goes away with a known-good PCM, replace the original PCM.
13. Clear the DTC with the HDS.
14. Start the engine, and warm it up to normal operating temperature (the radiator fan comes on). Drive the vehicle in 4th gear in the M position for more than 5 seconds. Slow down and stop the wheels.
15. Check the OBD STATUS in DTCs MENU for a pass/fail test of code P087?.
Did the result indicate a pass?
YES-The problem has been corrected.
NO-Return to step 1 and recheck.