P0967

DTC P0967: Problem in A/T Clutch Pressure Control Solenoid Valve B

NOTE:
^ Record all freeze data and review General Troubleshooting Information before you troubleshoot.
^ This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.

1. Clear the DTC with the HDS.
2. Check that DTC P0967 recurs.
Is DTC P0967 indicated?
YES-Go to step 6.
NO-Go to step 3.
3. Select P CTRL SOL CONTROL in MISCELLANEOUS TEST MENU, then select P. CONTROL SOL B in P CTRL SOL CTRL MENU with the HDS.
4. Set the A/T clutch pressure control solenoid valve B to 0.2A in SOL B CONTROL menu.
5. Check the OBD STATUS in DTCs MENU for a pass/fail test of code P0967.
Did the result indicate a fail?
YES-Go to step 6.
NO-Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the A/T clutch pressure control solenoid valve B and PCM. If the tester indicates NOT COMPLETE, return to step 3 and recheck.
6. Turn the ignition switch OFF.
7. Disconnect the A/T clutch pressure control solenoid valve B connector.





8. Measure A/T clutch pressure control solenoid valve B resistance at the solenoid connector.
Is there 3 - 10 ohms ?
YES-Go to step 9.
NO-Replace the A/T clutch pressure control solenoid valve B, then go to step 10.





9. Check for continuity between A/T clutch pressure control solenoid valve A connector terminal No. 2 and body ground.
Is there continuity?
YES-Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If the symptom/indication goes away with a known-good PCM, replace the original PCM.
NO-Repair open in the wire between the A/T clutch pressure control solenoid valve B and ground (G151), or repair poor ground (G151), then go to step 10.
10. Clear the DTC with the HDS.
11. Test-drive the vehicle for several minutes in the D position in all five gears.
12. Check the OBD STATUS in DTCs MENU for a pass/fail test of code P0967.
Did the result Indicate a pass?
YES-The problem has been corrected.
NO-Return to step 1 and recheck.