Audio-HVAC Display Module Assembly Removal/Installation

Audio-HVAC Display Module Assembly Removal/Installation

SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before performing repairs or service.

NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the dashboard and related parts.
- Lay a workshop towel under the parts when working on them to protect the face panel from scratches or other damage.

1. Make sure you have the anti-theft codes for the radio and navigation system, then write down the channels for the XM radio's preset buttons.
2. Remove the console trims and upper panel.




3. Remove the screws and bolts, then pull out the audio-HVAC display module assembly (A).
4. Disconnect the connectors (B) and antenna lead (C), then remove the audio-HVAC display module assembly.
5. Install the audio-HVAC display module assembly in the reverse order of removal, and note these items:
- Make sure all connectors and antenna lead are secure.
- Enter the anti-theft code for the radio, then enter the customer's XM radio channel presets, and set the clock.
- If necessary, enter the navigation system code.