ECM/PCM Update
ECM/PCM Updating and Substitution for TestingSpecial Tools Required
Honda Interface Module (HIM) EQS05A35570
Use this procedure when you have to substitute a known-good ECM/PCM in a troubleshooting procedure. Update the ECM/PCM only if the ECM/PCM does not have the latest software loaded.
NOTE: Do not turn the ignition switch OFF while updating the ECM/PCM. If you turn the ignition switch OFF before completion, the ECM/PCM can be damaged.
How to Update the ECM/PCM
NOTE:
- To ensure the latest program is installed, do an ECM/PCM update whenever the ECM/PCM is substituted or replaced.
- You can not update an ECM/PCM with the program it already has. It will only accept a new program.
- Before you update the ECM/PCM, make sure the vehicle's battery is fully charged.
- To prevent ECM/PCM damage, do not operate anything electrical (audio system, brakes, A/C, power windows, moonroof, door locks, etc.) during the update.
- If you need to diagnose the Honda Interface Module (HIM) because the HIM's red (#3) light came on or was flashing during the update, leave the ignition switch in the ON (II) position when you disconnect the HIM from the data link connector (DLC). This will prevent ECM/PCM damage.
1. Turn the ignition switch ON (II). Do not start the engine.
2. Connect the HDS or the Honda Interface Module (HIM) to the data link connector (DLC) (A) located under the driver's side of the dashboard.
3. Do the ECM/PCM update procedure as described on the HIM label and in the ECM/PCM update system.
4. Do the ECM/PCM idle learn procedure.
5. Do the CKP PATTERN Learn Procedure, if you did the troubleshooting for DTC P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0335, P0339, P0340, P0344, P0385 or P0389.
How to Substitute the ECM/PCM
1. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard
2. Turn the ignition switch ON (II).
3. Select READ DATA in the REPLACE ECM/PCM with the HDS.
4. Turn the ignition switch OFF.
5. Jump the SCS line with the HDS.
6. Pull back the carpet.
7. Remove the ducts (A).
8. Disconnect the ECM/PCM connectors (B).
9. Remove the bolts (C), then remove the ECM/PCM (D).
10. Install the ECM in the reverse order of removal.
11. Open the SCS with the HDS.
12. Turn the ignition switch ON (II).
NOTE: If DTC: P0630 "VIN Not Programmed or Mismatch" is stored at this time, ignore it and continue this procedure.
13. Input the VIN to the ECM/PCM with the HDS.
14. Select WRITE DATA in the REPLACE ECM/PCM with the HDS.
15. Rewrite the immobilizer code with the ECM/PCM replacement procedure in the HDS; it allows you to start the engine.
16. Reset the ECM/PCM with the HDS.
17. Do the Idle learn procedure
18. Do the CKP pattern learn procedure.