Throttle Cable/Linkage: Service and Repair
Throttle Cable Removal/Installation1. Remove the throttle cable cover.
2. Fully open the accelerator pedal position, then remove the throttle cable (A) from the throttle link (B).
3. Remove the cable housing (C) from the cable bracket (D).
4. Remove the throttle cable (A) from the accelerator pedal (B).
5. Install the cable in the reverse order of removal.
6. Start the engine. Hold the engine at 3,000 rpm with no load (in Park or neutral) until the radiator fan comes on, then let it idle.
7. Hold the cable, removing all slack from it.
8. Set the cable on the bracket (A).
Adjust the adjusting nut (B) so that its free play is 0 mm.
9. Position the adjusting nut on the other side of the bracket (A), then tighten the locknut (C).
10. With the cable properly adjusted, check the accelerator pedal position to be sure it goes to the full open stop fully when you push the accelerator pedal to the floor. Also check the accelerator pedal position to be sure it returns to the idle position stop whenever you release the accelerator pedal.