Reverse Shift Lever Clearance Inspection

Reverse Shift Lever Clearance Inspection





1. Measure the clearance between the reverse shift lever (A) and reverse shift fork (B) with a feeler gauge (C). If the clearance is more than the service limit, go to step 2.
Standard: 0.05 - 0.50 mm (0.002 - 0.020 inch)
Service Limit: 0.6 mm (0.024 inch)





2. Measure the width of the reverse shift lever.
- If the width is not within the standard, replace the reverse shift lever.
- If the width is within the standard, replace the reverse shift fork.
Standard: 6.400 - 6.650 mm (0.2520 - 0.2618 inch)





3. Measure the clearance between the reverse shift lever (A) and reverse shift piece (B) with a feeler gauge (C). If the clearance is more than the service limit, go to step 4.
Standard: 0 - 0.4 mm (0 - 0.015 inch)
Service Limit: 0.5 mm (0.020 inch)





4. Measure the width of the reverse shift lever.
- If the width is not within the standard, replace the reverse shift lever.
- If the width is within the standard, replace the reverse shift piece.
Standard: 13.0 - 13.2 mm (0.51 - 0.52 inch)