Back-Up Light Switch Test

Back-up Light Switch Test





1. Lay the fender cover over the fender, then remove the left rear engine compartment cover (A) and the left side engine compartment cover (B).
2. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the customer's XM radio channel presets. Make sure the ignition switch is OFF. Disconnect the negative (-) cable first, then the positive (+) cable from the battery. Remove the battery.
3. Remove the air cleaner housing.





4. Remove the battery base.





5. Disconnect the back-up light switch (A) 2P connector.
6. Check for continuity between the No. 1 and No. 2 terminals of the back-up light switch 2P connector. There should be continuity when the shift lever is in reverse.
7. If necessary, replace the back-up light switch. Apply liquid gasket (P/N 08718-0001) to the switch, and install it on the transmission housing. Tighten the back-up light switch to the specified torque.
8. Install the battery base.
9. Install the air cleaner housing.
10. Install the battery. Connect the positive (+) cable first, then the negative (-) cable to the battery.
11. Install the left rear engine compartment cover and the left side engine compartment cover.
12. Enter the anti-theft codes for the radio and navigation system, then enter the customer's XM radio channel presets.