A/T Clutch Pressure Control Solenoid Valve C Test
A/T Clutch Pressure Control Solenoid Valve C Test
1. Connect the HDS to the DLC (A).
2. Select LINEAR SOL TEST in MISCELLANEOUS TEST MENU on the HDS.
3. Do the LINEAR SOL C TEST in LINEAR SOL TEST MENU with the HDS.
4. Follow instructions indicated on the HDS by the tester result. A/T clutch pressure control solenoid valve C test has finished if the test result is OK. If the tester has not determined the cause of LINEAR SOL TEST, go to step 5.
5. Make sure you have the customer's radio and navigation anti-theft codes, and write down the XM radio channel presets.
6. Remove the left side engine compartment cover.
7. Make sure the ignition switch is OFF. Disconnect the battery negative terminal, then disconnect the battery positive terminal.
8. Remove the battery hold-down bracket, then remove the battery and battery tray.
9. Remove the air intake cover and air intake tube.
10. Remove the splash shield.
11. Remove the two bolts securing the battery base from under the vehicle, and remove the two bolts securing the battery base in the engine compartment, then remove the battery base.
12. Disconnect A/T clutch pressure control solenoid valve C connector, and check the connector for pin fit, corrosion, dirt, and oil. If the connector is OK, go to step 13. If the connector is not OK, repair the connector and do the test again.
13. Measure A/T clutch pressure control solenoid valve C resistance at the solenoid valve connector.
Standard: 3 - 10 ohms
14. If the resistance of the solenoid valve is out of standard, replace A/T clutch pressure control solenoid valve C.
15. If the resistance is within the standard, connect the battery negative terminal to A/T clutch pressure control solenoid valve C connector terminal No. 2, and connect the battery positive terminal to the terminal No. 1. A clicking sound should be heard.
16. If no sound is heard, replace A/T clutch pressure control solenoid valve C. If a clicking sound is heard, go to step 17.
17. Remove A/T clutch pressure control solenoid valve C.
18. Remove the gasket (A) and 8 x 12 mm ATF feed pipe (B).
19. Connect the battery negative terminal to A/T clutch pressure control solenoid valve C connector terminal No. 2, and connect the battery positive terminal to the terminal No. 1. Make sure A/T clutch pressure control solenoid valve C moves.
20. Disconnect one of the battery terminals and check valve movement at the fluid passage in the valve body mounting surface.
21. If the valve binds or moves sluggishly, or if the solenoid valve does not operate, replace A/T clutch pressure control solenoid valve C.
22. Check the fluid passage of the A/T clutch pressure control solenoid valve for dust and dirt, and clean the passage if necessary.
23. Install the 8 x 12 mm ATF feed pipe with its filter side into the transmission housing.
24. Install the new gasket in the mounting groove of the A/T clutch pressure control solenoid valve C body properly, then install A/T clutch pressure control solenoid valve C on the transmission housing. Do not pinch the gasket.
25. Install the battery base, then install the air cleaner housing and intake air duct.
26. Install the air intake cover and air intake tube.
27. Install the splash shield.
28. Install the battery tray, battery, and battery holddown bracket, then connect battery terminals.
29. Install the left side engine compartment cover.
30. Enter the radio and navigation anti-theft codes, and set the XM radio channel presets and the clock.