Transmission Gear Selection Switch Test
Transmission Gear Selection Switch Test1. Remove the center console.
2. Disconnect transmission gear selection switch/park pin switch connector.
3. Check for continuity between connector terminals No. 3 and No. 2. There should be continuity when shift lever in M position, and no continuity when shift lever in any position other than M.
4. Check for continuity between connector terminals No.7 and No. 2. There should be continuity when shift lever pushed toward to upshift position (+), and no continuity with released shift lever to neutral position.
5. Check for continuity between connector terminals No. 8 and No.2. There should be continuity when shift lever pulled toward to downshift position (-), and no continuity with released shift lever to neutral position.
- Replace the transmission gear selection switch/park pin switch assembly if the switch test was failed.
- Install the center console.