B1282

DTC B1282: Windshield Wiper Switch INT (AUTO) Position Circuit Malfunction

1. Clear the DTCs using the HDS.
2. Cycle the ignition switch to OFF and then back ON (II).
3. Turn the windshield wiper switch in MIST and wait for 2 seconds.
4. Turn the windshield wiper switch OFF and wait for 2 seconds.
5. Turn the windshield wiper switch in INT (AUTO) and wait for 2 seconds.
6. Turn the windshield wiper switch in LOW and wait for 2 seconds.
7. Turn the windshield wiper switch in HIGH and wait for 2 seconds.
8. Check for DTCs using the HDS.

Is DTC B1281, B1282, B1283, or B1284 indicated?

YES - Replace the windshield wiper/washer switch.

NO - Intermittent failure, the windshield wiper/washer switch and the combination switch control unit are OK at this time. Check pinfits and connections.