P0341

DTC P0341: CMP Sensor and CKP Sensor Incorrect Phase Detected

1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Test-drive at a steady speed between 19 - 38 mph (30 - 60 km/h) for 10 minutes.
4. Check for Temporary DTCs or DTCs in the DTCs MENU with the HDS.

Is DTC P0341 indicated?

YES - Go to step 9.

NO - Go to step 5.

5. Do the VTC TEST in the INSPECTION MENU with the HDS.

Is the result OK?

YES - Go to step 6.

NO - Go to step 9.

6. Test-drive at a steady speed between 19 - 38 mph (30 - 60 km/h) for 10 minutes.
7. Check the VTC STATUS in the DATA LIST with the HDS.

Does it indicate ON?

YES - Go to step 8.

NO - Go to step 6 and recheck.

8. Monitor the OBD STATUS for DTC P0341 in the DTCs MENU with the HDS.

Does the screen indicate FAILED?

YES - Go to step 9.

NO - If the screen indicates PASSED, intermittent failure, system is OK at this time. If the screen indicates NOT COMPLETED, go to step 6 and recheck.

9. Turn the ignition switch OFF.
10. Test the VTC oil control solenoid valve.

Is the VTC oil control solenoid valve OK ?

YES - Go to step 11.

NO - Replace the VTC oil control solenoid valve, then go to step 14.

11. Check the camshaft timing.

Is the camshaft timing OK?

YES - Go to step 12.

NO - Reset the camshaft timing, then go to step 14.

12. Check for damage to the cam chain.

Is the cam chain damaged?

YES - Replace the cam chain, then go to step 14.

NO - Go to step 13.

13. Inspect the VTC actuator.

Is the actuator OK?

YES - Go to step 14.

NO - Replace the VTC actuator, then go to step 14.

14. Turn the ignition switch ON (II).
15. Reset the ECM/PCM with the HDS.
16. Clear the CKP pattern with the HDS.
17. Do the ECM/PCM idle learn procedure.
18. Do the CKP pattern learn procedure.
19. Test-drive at a steady speed between 19 - 38 mph (30 - 60 km/h) for 10 minutes.
20. Check for Temporary DTCs or DTCs in the DTCs MENU with the HDS.

Are any Temporary DTCs or DTCs indicated?

YES - If DTC P0341 is indicated, check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM/PCM, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC troubleshooting.

NO - Go to step 21.

21. Monitor the OBD STATUS for DTC P0341 in the DTCs MENU with the HDS.

Does the screen indicate PASSED?

YES - Troubleshooting is complete.

NO - If the screen indicates FAILED, check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM/PCM, then go to step 1. If the screen indicates NOT COMPLETED, go to step 19 and recheck.