P2127
DTC P2127: APP Sensor B Circuit Low Voltage1. Turn the ignition switch ON (II).
2. Check APP SENSOR-B in the DATA LIST with the HDS.
Is there about 0.1 V, or less with the accelerator pedal fully pressed?
YES - Go to step 3.
NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at APP sensor B and at the ECM/PCM.
3. Turn the ignition switch OFF,
4. Disconnect the APP sensor 6P connector.
5. Turn the ignition switch ON (II).
6. At the wire harness side, measure voltage between APP sensor 6P connector terminals No.1 and No.2.
Is there about 5 V?
YES - Go to step 7.
NO - Go to step 15.
7. Turn the ignition switch OFF.
8. At the sensor side, measure resistance between APP sensor 6P connector terminals No.2 and No.3 with the throttle fully closed.
Is there about 0.35 - 0.45 kOhms?
YES - Go to step 9.
NO - Go to step 16.
9. At the sensor side, measure resistance between APP sensor 6P connector terminals No.1 and No.3 with the throttle fully closed.
Is there about 2.7 - 3.3 kOhms?
YES - Go to step 10.
NO - Go to step 16.
10. Jump the SCS line with the HDS.
11. Disconnect ECM/PCM connector A (31P).
12. At the wire harness side, check for continuity between APP sensor 6P connector terminal No 3 and body ground.
Is there continuity ?
YES - Repair short in the wire between APP sensor B and the ECM/PCM (A25), then go to step 17.
NO - Go to step 13.
13. Connect ECM/PCM connector terminal A25 to body ground with a jumper wire.
14. At the wire harness side, check for continuity between APP sensor 6P connector terminal No.3 and body ground.
Is there continuity?
YES - Go to step 22.
NO - Repair open in the wire between APP sensor B and ECM/PCM (A25), then go to step 17.
15. Measure voltage between ECM/PCM connector terminals A20 and A23.
Is there about 5 V?
YES - Repair open in the wire between the ECM/PCM (A20) and APP sensor B, then go to step 17
NO - Go to step 22.
16. Replace the APP sensor.
17. If disconnected, reconnect ECM/PCM connector A (31P).
18. Turn the ignition switch ON (II).
19. Reset the ECM/PCM with the HDS.
20. Do the ECM/PCM idle learn procedure.
21. Check for Temporary DTCs or DTCs in the DTCs MENU with the HDS.
Are any Temporary DTCs or DTCs indicated?
YES - If DTC P2127 is indicated, check for poor connections or loose terminals at APP sensor B and the ECM/PCM, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC troubleshooting.
NO - Troubleshooting is complete.
22. Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM.
23. Check for Temporary DTCs or DTCs in the DTCs MENU with the HDS.
Are any Temporary DTCs or DTCs indicated?
YES - If DTC P2127 is indicated, check for poor connections or loose terminals at APP sensor B and the ECM/PCM, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC troubleshooting.
NO - If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM.