B1161

DTC B1161: Gauge Control Module Lost Communication with Keyless Access Control Unit (REMOTE ID Message)

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test mode A.

1. Clear the DTCs with the HDS.
2. Turn the ignition switch OFF and then back ON (II).
3. Wait for 6 seconds.
4. Check for DTCs with the HDS.

Is DTC B1161 indicated?

YES - Go to step 5.

NO - Intermittent failure. The gauge control system is OK at this time.

5. Check for DTCs with the HDS.

Is DTC B2159 also indicated?

YES - Go to the Keyless Access Control Unit Input Test. Control Unit Input Test

NO - Go to the Gauge Control Module Input Test. Gauge Control Module Input Test