B1845

DTC B1845: Power Seat Recline Switch Circuit Malfunction

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test mode A.

1. Clear the DTCs with the HDS.
2. Turn the ignition switch OFF and then back ON (II).
3. Operate the recline switch in each direction for more than 1 second.
4. Check for DTCs with the HDS.

Is DTC B1845 indicated?

YES - Go to step 5.

NO - Intermittent failure. The driving position memory system is OK at this time. Check for loose or poor connections at the power seat control unit connector.

5. Turn the ignition switch OFF.
6. Disconnect power seat control unit connector A (40P).
7. Disconnect the power seat adjustment switch 12P connector and C901 under the driver's seat.




8. Check for continuity between body ground and power seat control unit connector A (40P) terminals No. 1, No. 6, and No. 25 individually.

Is there continuity?

YES - Repair a short in the wire.

NO - Go to step 9.




9. Check for continuity between these power seat control unit connector A (40P) terminals.

Is there continuity?

YES - Repair a short in the wire.

NO - Go to step 10.

10. Test the power seat adjustment switch.

Is the switch OK?

YES - Replace the power seat control unit.

NO - Replace the power seat adjustment switch.