B2129
DTC B2129: Steering Angle Sensor (STZ Signal) Mismatch 1NOTE: Before troubleshooting, check the VSA system DTCs. If the VSA system is OK, do this troubleshooting.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch OFF and then back ON (II).
3. Turn the headlight switch ON.
4. Turn the steering wheel from the center position to left or right position fully.
5. Check for DTCs with the HDS.
Is DTC B2129 indicated?
YES - Go to step 6.
NO - Intermittent failure, the adaptive front lighting system is OK at this time. Check for loose or poor connections at the steering angle sensor connector and at the adaptive front lighting control unit connector.
6. Check the steering angle sensor.
Is the steering angle sensor OK?
YES - Go to step 7.
NO - Faulty steering angle sensor, replace it.
7. Turn the ignition switch OFF.
8. Remove the steering column covers.
9. Disconnect the steering angle sensor 5P connector.
10. Disconnect the adaptive front lighting control unit 40P connector.
11. Disconnect the VSA modulator-control unit 47P connector.
12. Check for continuity between steering angle sensor 5P connector terminal No. 3 and adaptive front lighting control unit 40P connector terminal No. 17.
Is there continuity?
YES - Faulty adaptive front lighting control unit, replace it and do the adaptive front lighting control unit learning procedure.
NO - Repair an open in the wire.