P2184

DTC P2184: ECT Sensor 2 Circuit Low Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.

1. Turn the ignition switch ON (II).
2. Check ECT SENSOR 2 in the DATA LIST with the HDS.

Is about 356 degrees F (180 degrees C) or higher, or 0.08 V or less indicated?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at ECT sensor 2 and the PCM.

3. Turn the ignition switch OFF.
4. Disconnect ECT sensor 2 2P connector.
5. Turn the ignition switch ON (II).
6. Check ECT SENSOR 2 in the DATA LIST with the HDS.

Is about 356 degrees F (180 degrees C) or higher, or 0.08 V or less indicated?

YES - Go to step 7.

NO - Go to step 11.

7. Turn the ignition switch OFF.
8. Jump the SCS line with the HDS.
9. Disconnect PCM connector B (24P).




10. Check for continuity between ECT sensor 2 2P connector terminal No. 1 and body ground.

Is there continuity?

YES - Repair short in the wire between ECT sensor 2 and the PCM (B24), then go to step 13.

NO - Go to step 18.

11. Turn the ignition switch OFF.
12. Replace ECT sensor 2.
13. Reconnect all connectors.
14. Turn the ignition switch ON (II).
15. Reset the PCM with the HDS.
16. Do the PCM idle learn procedure.
17. Check for Temporary DTCs or DTCs with the HDS.

Are any Temporary DTCs or DTCs indicated?

YES - If DTC P2184 is indicated, check for poor connections or loose terminals at ECT sensor 2 and the PCM, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.

NO - Troubleshooting is complete.

18. Update the PCM if it does not have the latest software, or substitute a known-good PCM.
19. Check for Temporary DTCs or DTCs with the HDS.

Are any Temporary DTCs or DTCs indicated?

YES - If DTC P2184 is indicated, check for poor connections or loose terminals at ECT sensor 2 and the PCM, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.

NO - If the PCM was updated, troubleshooting is complete. If the PCM was substituted, replace the original PCM.