Lighting - High Mount Brake Lamp Cover Loose/Falls Off

09-022

July 20, 2010

*Applies To:
2005-10 RL - ALL*

High Mount Brake Light Cover Is Loose or Falls Off

(Supersedes 09-022, dated June 6, 2009, to revise the information marked with the asterisks)

*REVISION SUMMARY

Under Applies To, 2010 models were added.*

SYMPTOM

The high mount brake light cover is loose or falls off.

PROBABLE CAUSE

The clips on the high mount brake light cover are incorrectly installed.

CORRECTIVE ACTION

Remove the high mount brake light cover, install the clips correctly, then reinstall the cover.

PARTS INFORMATION

Snap Fitting (clip): P/N 90666-SJA-003

WARRANTY CLAIM INFORMATION

The normal warranty applies.

Operation Number: 8570A4

Flat Rate Time: 0.2 hour

Failed Part: P/N 34273-SJA-000ZC

Defect Code: 08001

Symptom Code: 06101

Skill Level: Repair Technician

REPAIR PROCEDURE





1. Remove the high mount brake light cover.

2. Check for any clips that may still be attached to the vehicle body, and remove them.

3. Push the back half of the clips on the brake light cover as shown. Make sure the round side is facing outward.





NOTE:
If any clips are missing or damaged, replace them with new ones.

4. Reinstall the high mount brake cover, and make sure the cover fits tightly. If loose, recheck the clip installation.





Disclaimer