DTC 15-3

DTC 15-3: Faulty OPDS Sensor

NOTE: Aftermarket devices (fluorescent lights, laptop computers, etc.) used near the front passenger's seat-back can interfere with the seat-back sensors and cause a false DTC 15-3. If one of these devices was used, erase the DTC, operate the device near the seat-back, and recheck for DTCs. If DTC 15-3 is reset, erase it, and do not use the device near the seat-back.

1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures.

3. Check the connection at the OPDS sensor harness connector and the OPDS unit connector.

Are the connections OK?

YES - Go to step 4.

NO - Reconnect the OPDS sensor harness connector, and clear the DTC.

4. Replace the OPDS sensor/seat-back foam, and reinitialize the OPDS system.
5. Erase the DTC memory, then check for DTC 15-3.

Is DTC 15-3 indicated?

YES - Replace the OPDS unit.

NO - The system is OK.