P0967
DTC P0967: Problem in A/T Clutch Pressure Control Solenoid Valve BNOTE:
^ Record all freeze data and review General Troubleshooting Information before you troubleshoot.
^ This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
1. Clear the DTC with the HDS.
2. Check that DTC P0967 recurs.
Is DTC P0967 indicated?
YES: Go to step 6.
NO: Go to step 3.
3. Choose Clutch Pressure Control Solenoid Control in Miscellaneous Test Menu, and test the A/T clutch pressure control solenoid valve B with the HDS.
4. Drive with the A/T clutch pressure control solenoid valve B at 0.2A in Clutch Pressure Control Solenoid Control menu.
5. Check the OBD status in DTC Monitor Tool from DTCs/Freeze Data in A/T Mode Menu for a pass/fail test of code P0967.
Did the result indicate a fail?
YES: Go to step 6.
NO: Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the A/T clutch pressure control solenoid valve B and PCM. If the tester indicates NOT COMPLETE, return to step 3 and recheck.
6. Turn the ignition switch OFF.
7. Disconnect the A/T clutch pressure control solenoid valve B connector.
8. Measure A/T clutch pressure control solenoid valve B resistance at the solenoid connector.
Is there 3 - 10 Ohms?
YES: Go to step 9.
NO: Replace the A/T clutch pressure control solenoid valve B, then go to step 10.
9. Check for continuity between A/T clutch pressure control solenoid valve B connector terminal No. 2 and body ground.
Is there continuity?
YES: Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If the symptom/indication goes away with a known-good PCM, replace the original PCM.
NO: Repair open in the wire between the A/T clutch pressure control solenoid valve B and ground (G101), or repair poor ground (G101), then go to step 10.
10. Clear the DTC with the HDS.
11. Test-drive the vehicle for several minutes in the D position in all five gears.
12. Check the OBD status in DTC Monitor Tool from DTCs/Freeze Data in A/T Mode Menu for a pass/fail test of code P0967.
Did the result indicate a pass?
YES: The problem has been corrected.
NO: Return to step 1 and recheck.