Cowl Moulding / Trim: Service and Repair

Cowl Cover Replacement

1. Remove the windshield wiper arms.




2. Using a clip remover, detach the clips (A), then remove the hood rear seal (B), and detach the clips (C) from the cowl covers. Take care not to scratch the cowl covers.
3. Detach the clips (D, E) and release the hook (F) by carefully pulling the passenger's cowl cover (G) upward. Pull the cover forward to release the hooks (H), and pull the hinge cover (I) out from the front fender (J), then remove the cover. Take care not to scratch the body.
4. Remove the windshield wiper subharness grommet (K) from the driver's cowl cover (L).
5. Detach the clips (D, E) by carefully pulling the driver's cowl cover upward, and pull the cover forward to release the hooks (M). Pull the hinge cover (N) out from the front fender (O), then remove the cover. Take care not to scratch the body.
6. Install the cover in the reverse order of removal, and note these items:
- Replace any damaged or stress-whitenings clips.
- Push the clips into place securely.