Coolant: Service and Repair
Coolant Replacement1. Start the engine. Set the heater temperature control dial to maximum heat, then turn off the ignition switch. Make sure the engine and radiator are cool to the touch.
2. Remove the radiator cap.
3. Loosen the drain plug (A), and drain the engine coolant.
4. Remove the splash shield.
5. Remove the reserve tank drain cap (A), and drain the engine coolant.
6. After the coolant has drained, tighten the radiator drain plug securely, and install the reserve tank drain cap securely.
7. Fill the reserve tank to the MAX mark (A) with Honda All Season Antifreeze/Coolant Type 2 (P/N OL999-9001).
8. Pour Honda All Season Antifreeze/Coolant Type 2 into the radiator up to the base of the filler neck.
NOTE:
^ Always use Honda All Season Antifreeze/Coolant Type 2 (P/N OL999-9001). Using a non-Honda coolant can result in corrosion, causing the cooling system to malfunction or fail.
^ Honda All Season Antifreeze/Coolant Type 2 is a mixture of 50% antifreeze and 50% water. Do not add water.
9. Install the radiator cap loosely.
10. Start the engine, and let it run until it warms up (the radiator fan comes on at least twice).
11. Turn off the engine. Check the level in the radiator and add Honda All Season Antifreeze/Coolant Type 2 if needed.
12. Put the radiator cap on tightly, then run the engine again and check for leaks.
13. Install the splash shield.