B1233

DTC B1233 or DTC indicator I: An Open in the Driver's Air Mix Control Motor Circuit

1. Clear the DTC by turning the ignition switch OFF, and then ON (II).
2. Operate the climate control system in several modes.
3. Check for DTCs using the self-diagnostic or HDS.

Is DTC B1233 or I indicated?

YES - Go to step 4.

NO - Intermittent failure, check for loose wires or poor connections on the driver's air mix control motor circuit.

4. Turn the ignition switch OFF.
5. Test the driver's air mix control motor.

Is the driver's air mix control motor OK?

YES - Go to step 6.

NO - Replace the driver's air mix control motor.

6. Disconnect the driver's air mix control motor 5P connector.
7. Disconnect climate control unit connector A (20P) and B (16P).




8. Check for continuity between the following terminals of climate control unit connector A (20P) and B (16P) and the driver's air mix control motor 5P connector.

Is there continuity?

YES - Check for loose wire or poor connections at climate control unit connector A (20P) and B (16P) and at the driver's air mix control motor 5P connector. If the connections are good, substitute a known-good climate control unit and recheck. If the symptom/indication goes away, replace the original climate control unit.

NO - Repair any open in the wire(s) between the climate control unit and the driver's air mix control motor.