B1706

DTC B1706: Display Panel Control Unit Lost Communication with the Gauge Control Module (VSS/NE Signal)

NOTE:
- Display panel control unit DTCs may not clear using the HDS. If the DTCs will not clear, manually reset the display panel control unit.
- If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN system diagnosis test mode A.

1. Clear the DTC with the HDS.
2. Turn the ignition switch OFF, and then back ON (II).
3. Check for DTCs with the HDS.

Are DTCs B1011, B1060, and B1805 indicated?

YES - Go to the Gauge Control Module Input Test. Gauge Control Module Input Test

NO - Replace the display panel control unit.