P2627

DTC P2627: Rear A/F Sensor (Bank 1, Sensor 1) LABEL Circuit Low Voltage (2004 - 2005 models)

DTC P2630: Front A/F Sensor (Bank 2, Sensor 1) LABEL Circuit Low Voltage (2004 - 2005 models)

NOTE:
- Information marked with an asterisk (*) applies to the front bank (Bank 2).
- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.

1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine. Hold the engine speed at 3,000 rpm without load (in Park or neutral) until the radiator fan comes on, then let it idle 2 minutes.
4. Check for Temporary DTCs or DTCs with the HDS.

Is DTC P2627 and/or P2630* indicated?

YES - Go to step 5.

NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the ECM/PCM.

5. Turn the ignition switch OFF.
6. Jump the SCS line with the HDS.
7. Disconnect ECM/PCM connector B (24P).




8. Check for continuity between ECM/PCM connector terminal B10 (B19)* and body ground.

Is there continuity?

YES - Go to step 9.

NO - Go to step 17.

9. Disconnect the A/F sensor (Sensor 1) 8P connector.




10. Check for continuity between ECM/PCM connector terminal B10 (B19)* and body ground.

Is there continuity?

YES - Repair short in the wire between the ECM/PCM (B10 (B19)*) and the A/F sensor (Sensor 1), then go to step 12.

NO - Go to step 11.

11. Replace the A/F sensor (Sensor 1).
12. Reconnect all connectors.
13. Turn the ignition switch ON (II).
14. Reset the ECM/PCM with the HDS.
15. Do the ECM/PCM idle learn procedure.
16. Check for Temporary DTCs or DTCs with the HDS.

Are any Temporary DTCs or DTCs indicated?

YES - If DTC P2627 and/or P2630* is indicated, check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the ECM/PCM, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.

NO - Troubleshooting is complete.

17. Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM.
18. Check for Temporary DTCs or DTCs with the HDS.

Are any Temporary DTCs or DTCs indicated?

YES - If DTC P2627 and/or P2630* is indicated, check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the ECM/PCM, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.

NO - If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM.